60 Minute Forced Entry/Bullet Resistant Door
The FDI60M Forced Entry Resisting Door System is capable of resisting 60 minutes of forced entry assault and defeating multiple impacts of 7.62mm NATO and 5.56mm projectiles as defined by applicable U.S. Government Standards.
Features
- Provides 60 minute Forced Entry Protection
- Multi-impact high power rifle resistant
- Heavy duty steel construction
- Door and frame shipped as a complete unit
- Opaque only
- Opaque - DOS 2133 GDO-60R-FDI-01
Basic Use
This door system is used to provide protection in those areas susceptible to mob or terrorist attacks. Applications are likely to be at safe haven rooms where prolonged protection is required.
Limitations
This door has been designed to meet the rigid specifications developed by the U.S. Government for 60-minute forced entry and high power rifle impact. It is recommended that each end user determine the ballistic and forced entry threat and choose the appropriate product to meet and resist that threat.
Specifications/Construction
Door construction: Doors and frames are full flush construction of ballistic steel plates and 1 ½” steel tube. Vertical jambs and header contain bullet-resisting material equal to protection level of the door.
Door Frame Construction: Door frame assembly is constructed of steel tubes. Framing dimensions are 2” wide x 5 ½” deep. Door frames are completely fabricated at factory and shipped with doors attached. All doors are pre-tested for all locking functions, clearances, and ease of operation, to ease field installation. All joint connections are welded to provide a rigid assembly when installed. The doorstop is built into the frame. Frames are predrilled to accept ½” anchors 12” on center. Shims are provided to take up a space at each anchor. Wiring diagrams are shipped enclosed in the hardware packages.
Hardware Assembly: Each door is equipped as follows:
- Door Closer (LCN 4041 CUSH)
- (3) Forced Entry Locks (Adams Rite 1850S w/ 15tt Thumbturns)
- (2) Brookfield i8513 5" x 5.5" needle bearing hinges
- Aluminum Threshold (Pemko 177AV36)
- Weather Stripping (Pemko SS88D17)
Optional Hardware: Refer to the SHW group page for additional hardware information. You must select a lockset, pull handle, or panic device
that suits your application. Most hardware is shipped pre-assembled with the door unit.
Subframes: To meet forced entry requirements of DOS SD.STD-01.01 (Rev. G amended), steel tube subframes ¼” wall thickness minimum,
must be attached to concrete or masonry with Hilti® Epoxy Anchoring System. An acceptable alternative is the use of steel embeds, ½” thick minimum.
These systems are included as options in our product line.
Finish: All doors and frames are furnished prime painted, ready for final finish in field. Options: Factory can apply polyurethane enamel; link to color chart is available on the main page. Doors can also be fitted with various types of architectural metals.
Applicable Standard
- DOS SD.STD-01.01 (Rev. G amended)
Weights and Measurements
Standard Door:
Door Thickness: 2”
Frame Depth: 5 ½”
Door Size: 36” x 84”
Frame Size: 40” x 86”
Rough Opening: 41 ½” x 86 ¾”
Gap Cover Dimension 41” x 86 ½”
Shipping Weight: 1500 lbs